ClearOne NetStreams DigiLinX Dealer User Manual
Page 115
Editing Devices
5-45
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
2.
Click on the ControLinX in the MediaLinX MLA4000 you want to edit in the project.The IR/RS232 Settings
tab for the ControLinX using the General Purpose Driver/IR displays in the right side of the window (see
Figure 5-37). This connection is for an IR device or subsystem.
Figure 5-37
Settings for the ControLinX IR/RS232 tab
The IR/RS232 Settings tab allows you to configure settings for the external system. Consult the manual of the
interfaced system for the appropriate settings.
NOTE:
When the General Purpose Driver/IR is used, there are no communications settings to define. The remote
control for the device is required to learn the IR commands. See IR Tools on page 7-1.
Table 5-27 provides information on the fields available for editing the IR/RS232 Settings tab.
3.
After adjusting information, select Apply.
4.
Select the Labels tab.
The Labels tab for the ControLinX using the General Purpose Driver displays in the right side of the window
(see Figure 5-38).
Table 5-27
ControLinX IR/RS232 Settings Tab
Tab
Selection Description
IR/RS232 Settings
Service Name
A display field used to denote the stream name.
Driver
The driver used for the device connected to the ControLinX.
Control Type
For the Generic Driver these settings are dependent on the
device being hosted by the ControLinX100.