Prerequisites, Installer requirements, Pc requirements – ClearOne NetStreams DigiLinX Dealer User Manual
Page 10: Prior to installation, Prerequisites -2, Installer requirements -2 pc requirements -2, Prior to installation -2
DigiLinX Dealer Setup Version 2.35.00
1-2
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Prerequisites
Before you begin installing and configuring the DigiLinX IP-Based Multi-Room
Audio and Video Distribution and Control system, please note the following
prerequisites.
Installer Requirements
This manual assumes the installer:
has completed DigiLinX Dealer Certification Training and other training such as
Custom Electronic Design and Installation Association’s (CEDIA’s) boot camp
knows how to install audio keypads and connect audio components
knows how to install and connect video components
knows how to use basic installation tools such as an RJ45 crimper to terminate
CAT5 cables
has pulled all necessary wire to the locations where the preamp, keypads, and
speakers are to be installed
understands basic Microsoft
®
Windows
®
commands such as how to browse, create
folders, save files, etc.
For more information on meeting the prerequisites, contact NetStreams Technical
Support at +1866-353-3496.
PC Requirements
The minimum PC requirements for the DigiLinX Dealer Setup Program are:
Windows XP operating system with SP2 or Windows Vista
512 MB of RAM (XP) 1GB of RAM (Vista)
1.2GHz processor (1.6GHz processor recommended).
Prior to Installation
The following are important to know before installing the DigiLinX system:
Cable Connections. Ensure all cables are connected and terminated properly as
covered in the DigiLinX Installation and Design Guide
Firewall. Temporarily disable all firewalls that may be running on your PC
IP Addressing for third-party hardware. Set the IP address for IP cameras and
speakers prior to configuring them in DigiLinX. Consult the product user’s guide
for information on setting the IP address
Diagnostics Tool. Run diagnostics to test your connection. This is covered in
Diagnotics in Chapter 17.
Restart. Restarting your PC enables some network setting changes. To restart, close
the DigiLinX Dealer Setup program and reboot your computer.