Controlinx and the lutron radiora lighting system, After adjusting information, select apply, Input sensor tab – ClearOne NetStreams DigiLinX Dealer User Manual
Page 103
Editing Devices
5-33
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
NOTE:
If using an ELK-930, set the Sensor Trigger Level to Signal Toggles, and set the Action to the desired
amount of time.
3.
After adjusting information, select Apply.
ControLinX and the Lutron RadioRA Lighting System
To edit ControLinX settings for RadioRA, complete the following steps:
1.
Using the NetStreams RS232 cable, connect the RadioRA using the RS232 (serial connection) on the
Chronos™ unit.
2.
Click on the ControLinX in the MediaLinX MLA4000 you want to edit in the project.
The IR/RS232 Settings tab for the ControLinX hosting a RadioRA displays in the right side of the window
(see Figure 5-28).
Figure 5-28
ControLinX with RadioRA IR/RS232 Settings tab
Table 5-17
Input Sensor Tab
Tab
Selection Description
Input Sensor
Sensor Trigger Level
Provides the following sensor options:
High Signal
Low Signal
Signal Toggles
Action
Allows you to mute the signal by factors of 10, 15, or 30
seconds when the doorbell is pressed.
Sensor Adjustment
Adjusts the sensitivity of the input sensor.