After adjusting information, select apply, Controlinx ir/rs232 settings tab – ClearOne NetStreams DigiLinX Dealer User Manual
Page 130
DigiLinX Dealer Setup Version 2.35.00
5-60
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
3.
Make sure the baud rate of the Vantage controller matches the baud rate setting on this screen (19200).
4.
After adjusting information, select Apply.
5.
Select the Labels tab.
The Labels tab for the ControLinX hosting a Vantage displays in the right side of the window (see Figure 5-
48).
Figure 5-50
Labels tab for the ControLinX hosting a Vantage
Table 5-37
ControLinX IR/RS232 Settings Tab
Tab
Selection Description
IR/RS232 Settings
Service Name
Used to name the device.
Driver
The driver used for the connected device.
Driver File
The driver file used to communicate with the device.
NOTE:
Once you’ve selected Vantage as the driver for this
ControLinX, you will not be able to change it to any
other device without removing the CL100 from the
device list and re-adding it.
Control Type
Defined by the specific product driver.
Baud Rate
Set at 19200.
Data Bits
Information provided by the manufacturer of the attached
device.
Parity
Information provided by the manufacturer of the attached
device.
Stop Bits
Information provided by the manufacturer of the attached
device.