Eppendorf epBlue with MultiCon - Manual (Page 51)

epBlue Application Editor - Creating and editing applications
epBlue™ with MultiCon
English (EN)
51
6.3.1.3 Sample transfer > Mix command
The Mix command is also available for mixing (see p. 63).
Abb. 6-10: Sample transfer > Mix
Fig. 6-10: Sample transfer > Mix
Reuse tips Returned pipette tips will be reused.
The pipette tips will be reused within an application for the same source vessel.
Is only executed if the
restore tips option was selected in a previous command
and the restored tips are available.
The
Reuse tips checkbox is only available with specific settings of the Change
Tip option.
Information on the aspiration and transfer of liquids can be found in the hardware operating
manual.
Mix before aspirating Mix before each aspiration. Set the parameters following activation.
If you transfer a larger volume than the maximum volume of the pipette, the
liquid will be mixed before the first aspiration.
Mix after dispensing Mix after each dispensing. Set the parameters following activation. Available
for
Transfer type > Pipette .
If you transfer a larger volume than the maximum volume of the pipette, the
liquid will be mixed after the last aspiration.
No. of Cycles Number of mixing cycles.
Speed Mixing frequency. If no entries were made for Speed , the defined aspiration
speed of the liquid type will be used.
Volume Mixing volume
Fixed height Position of the pipette tip on the Z-axis. Fixed aspiration level and dispensing
level. Only for levels below the working volume.
Aspiration Distance between the pipette tip and base of the vessel during aspiration. If
0
mm is entered, the distance will be corrected to 2 mm. The correction is
dependent on the bottom tolerance and type of labware.