Eppendorf epBlue with MultiCon - Manual (Page 34)

epBlue Application Runner - Carrying out the application
epBlue™ with MultiCon
English (EN)
34
4.3 Starting the application
Prerequisites
• The labware is positioned on the epMotion worktable.
• epMotion is ready for operation.
• The application run was prepared. (see p. 26)
Click on the Run button.
The application starts.
4.4 Controlling the application
Abb. 4-9: Running application
Fig. 4-9: Running application
Control the application with the buttons from the Control area.
Carrying out the application. The epMotion executes the
application until the end.
Executing the application step-by-step. The epMotion
executes the next step and then stops.
Pause. The application stops, but it will not be aborted.
Aborting the application. If you have stopped the
application using the button, the
button is now
active.
Procedure area
Commands. The active command is
highlighted blue.
Worktable area
Worktable.
Remaining Runtime area
Status of the application/runtime of the
application/total time for the application.
Log area
Log.