Eppendorf epBlue with MultiCon - Manual (Page 169)

epBlue - Software error messages
epBlue™ with MultiCon
English (EN)
169
0x211D Mixing cycles in
source not defined Parameter No. of Cycles in a
mix procedure was not edited
for the source in the
application (mix procedure as
defined in a command
Mix or
as part of a liquid transfer
command via parameter
Options ).
See explanation in
"Cause".
0x211E Invalid entry for
mixing cycles in
source (1
... 99)
Entry for the No. of Cycles
parameter in a mix procedure
for source vessels was higher
than the max. limit (1
up to 99
cycles) (mix procedure as
defined in a command
Mix or
as part of a liquid transfer
command via parameter
Options ).
Enter a number between
1 and 99 for the
No. of
Cycles parameter.
0x211F Invalid entry for
mixing speed in
source (1
... 10)
Entry for the parameter Speed
in a mix procedure for source
vessels was higher than the
max. limit (1
up to 10) (mix
procedure as defined in a
command
Mix or as part of a
liquid transfer command via
parameter
Options ).
Enter a number between
1 and 10 for the
Speed
parameter.
0x2120 Mixing volume in
source not defined Parameter Volume in a mix
procedure for source vessels
was not edited in the
application (mix procedure as
defined in a command
Mix or
as part of a liquid transfer
command via parameter
Options ).
See explanation in
"Cause".
0x2121 Parameter conflict:
mixing volume in
source too large for
this tool The Volume and Pipet. Tool
parameters of a mix procedure
for source vessels are not in
agreement (
Volume is higher
than the upper limit of the
tool's volume range) (mix
procedure as defined in a
command
Mix or as part of a
liquid transfer command via
parameter
Options ).
Edit Volume and Pipet. Tool
so that Volume is within
pipette tool's volume
range.
Code Symptom/message Cause Remedy