Eppendorf epBlue with MultiCon - Manual (Page 35)

epBlue Application Runner - Carrying out the application
epBlue™ with MultiCon
English (EN)
35
4.5 Ending the application
When the application run is finished, a message appears.
1. To confirm the message press the OK button.
2. In the Application Runner window, press the Next button.
The final window appears. If your epMotion is equipped with a HEPA air filter and UV lamp, you can
activate the HEPA air filter and the UV lamp.
Abb. 4-12: Final window
Fig. 4-12: Final window
3. Activate the HEPA air filter, if necessary.
Prerequisites
The worktable of the device must be cleared completely before activating the UV lamp.
4. Activate the UV lamp, if necessary.
5. Press the Exit button to end the application.
Abb. 4-10: The application is finished
Fig. 4-10: The application is finished
Abb. 4-11: The application was canceled
Fig. 4-11: The application was canceled