Eppendorf epBlue with MultiCon - Manual (Page 45)

epBlue Application Editor - Creating and editing applications
epBlue™ with MultiCon
English (EN)
45
6.2.8 Defining procedures
A procedure is a defined sequence of commands that epMotion executes during an application.
Commands are described in the Commands chapter (see p. 47).
The first command of each procedure is the Procedure Start command. The Procedure Start command is
created automatically and cannot be deleted. The Procedure Start command shows the epBlue worktable at
the start of the application. The Procedure Start command does not influence the application.
The software does not include a command for aspirating pipette tips. The user defines which pipette tips
will be used in one command. The user must provide for the corresponding pipette tips on the worktable.
The user defines the dispensing tool with each command. Tools are picked up according to the command
parameters.
Abb. 6-6: Creating a procedure for an application
Fig. 6-6: Creating a procedure for an application
Commands column
Available commands.
Procedure column
Sequence of commands. The commands are
executed in the order displayed.
Worktable
The state of the worktable during the execution of
the selected command.
Options area
Parameter of the selected command.