Eppendorf epBlue with MultiCon - Manual (Page 171)

epBlue - Software error messages
epBlue™ with MultiCon
English (EN)
171
0x2127 Mixing volume in
destination not
defined Parameter Volume in a mix
procedure for destination
vessels was not edited in the
application (mix procedure as
part of a liquid transfer
command via parameter
Options ).
See explanation in
"Cause".
0x2128 Parameter conflict:
mixing volume in
destination too
large for this tool The Volume and Pipet. Tool
parameters in a mix procedure
for destination vessels do not
match (
Volume is higher than
the upper limit of the tool
volume range) (mix procedure
as part of a liquid transfer
command via parameter
Options).
Edit Volume and Pipet. Tool
so that Volume is within
the pipette tool's volume
range.
0x2129 Parameter conflict:
mixing volume in
destination too
small for this tool The Volume and Pipet. Tool in
a mix procedure for
destination vessels do not
match (
Volume is lower than
the minimum allowed volume)
(mix procedure as part of a
liquid transfer command via
parameter
Options ).
Edit Volume and Pipet. Tool
so that Volume is within
the volume range of the
pipet tool.
0x212A Parameter conflict:
mixing volume in
destination greater
than filling volume
of destination tube
or well The Volume and Destination
parameters in a mix procedure
for destination vessels do not
match (
Volume is higher than
the maximum filling volume of
the destination vessel) (mix
procedure as part of a liquid
transfer command via
parameter
Options ).
Edit Volume and
Destination so that Volume
is within the maximum
filling volume of the
destination vessel.
0x212C Parameter conflict:
mix after dispense
not allowed in
multidispense
mode When the transfer type
parameter is set to
multidispense , the mix after
dispense parameter cannot be
edited for this command.
Change parameter transfer
type to pipette , or:
Omit the mixing step; in
this case you could also
edit another mixing step as
a new command (
Mix ),
which would be performed
after the previous
command of the procedure
has ended.
Code Symptom/message Cause Remedy