Ag Leader Yield Monitor 2000 Operators Manual - Manual (Page 91)

Yield Monitor 2000
Grain Type
Ag Leader Technology
June 1997
4-26a
Changing Grain
Type Name You can change any of the existing grain type names (except the four corn
types) to any name (up to 11 characters long) of your choice. Follow these
steps to change the grain name:
Step Action
1 Press the LOAD key to display a load and then press the GRAIN key
to display the grain type.
2 Use the bottom-left UP or DOWN ARROW keys to change the grain
type to the one that you want to change the name.
3 To get a cursor (underline character) to appear to the left of the
grain type name, press the WEIGHT key once and then press the
GRAIN key again to display the grain type again on the bottom-left
of the display. You should now see a cursor to the left of the grain
type name.
4 Use the RIGHT ARROW key to move the cursor over to the first
character that you want to change. Use the bottom-left UP or
DOWN ARROW keys to scroll through the characters that can use
for the new name.
5 Repeat step 4 and change the characters necessary for the new name.
Note: Changing the name of the grain type does not affect any of the other
settings or calibration numbers that are associated with that grain type.
Note: To change all the grain type names back to their original names shut
the monitor off, hold down the GRAIN key and turn on the monitor.
Copying
Calibration
Numbers to
another Grain
Type You can copy the grain calibration numbers (C1-C11 numbers) from one
grain type to another (exception: can not copy to or from a non-corn type to
a any of the four corn types). This feature is useful if you change to a grain
type that has the same calibration as another grain type. Follow these steps
to copy the calibration numbers:
Step Action
1 Press the MEM key until “PRESS YES TO COPY CAL” is
displayed.
2 Use the bottom-left UP or DOWN ARROW keys to change to the
grain type for which you want the calibration numbers copied from.
3 Use the bottom-right UP or DOWN ARROW keys to change to the
grain type for which you want the calibration numbers copied to.
4 Press the YES key.