Ag Leader Yield Monitor 2000 Operators Manual - Manual (Page 90)

Grain Type
Yield Monitor 2000
Ag Leader Technology
June 1997
4-26
Introduction You can have only one grain type per field. If you have one field with two
different crops in it (example: 80 acre field with 40 acres of soybeans and 40
acres of corn), you must use two fields

one for each grain type

in the
monitor.
Each grain type has the following settings.
•
Grain calibration numbers (C2-C11, monitor sets these when calibrated)
•
Moisture calibration number
•
Dry % value (for example, 13% for soybeans)
•
Dry lbs/bu
•
Vibration calibration number (C1)
•
Swath setting
•
Stop height number
Dry lbs/bu You can set the dry lbs/bu of the grain for each grain type except corn (56
lbs/bu), soybeans (60 lbs/bu), and wheat (60 lbs/bu). Follow these steps to
set the dry lbs/bu:
Step Action
1 Press the GRAIN key until “xx DRY LB/B” appears on the display.
2 Use the bottom-left UP or DOWN ARROW keys to change the
value.
Note: This will change the bushels for all loads set on that grain
type.
Dry % Moisture Follow these steps to set the dry % value:
Step Action
1 Press the GRAIN key until “xx.x DRY %” appears on the display.
2 Use the bottom-left UP or DOWN ARROW keys to change the
value.
Note: This will change the bushels for all loads set on that grain
type.