Ag Leader Yield Monitor 2000 Operators Manual - Manual (Page 125)

Yield Monitor 2000
Printing Field/Load Summary
Ag Leader Technology
June 1997
4-59
Step Action
1 Click on File.
2 Click on Properties.
3 Click on Configure, then ensure the parameters are correct.
•
If the parameters are correct, follow these steps to select a different
COM port.
Step Action
1 Click on File.
2 Click on Properties.
3 Change to a different COM port.
4 Click on Configure to set the parameters for the new COM port
according to Step 8 in the HyperTerminal Setup (Windows 95)
section above.
•
If communications are not established, check the cable connection to see
whether it is connected to something other than a COM port.
•
If communications still are not established, follow these steps:
Step Action
1 Turn off the yield monitor, then turn it back on.
2 Press the MEM key.
3 Set the monitor to “READY TO PRINT”.
4 Press Enter (Return key) on the PC keyboard and look for the
message “Type PRINT, NAME or START & press Enter”
•
If you are unable to establish communications, call Ag Leader
Technology at 515-232-5363 for assistance.