Ag Leader Yield Monitor 2000 Operators Manual - Manual (Page 26)

Setting DRY % Moisture,
Yield Monitor 2000
Dry Lbs/Bu Ag Leader Technology
June 1997
2-22
Setting Dry %
Moisture Follow these procedures to set dry % moisture:
Step Action
1 Press the GRAIN key until a grain type appears on the display and
use the bottom-left UP or DOWN ARROW keys to set a grain type
you will harvest.
Note: You must have the load displayed to change the grain type.
2 Press the GRAIN key until “xx.x DRY %” appears on the display,
then use the bottom-left UP or DOWN ARROW keys to set Dry %
to the moisture level you want the monitor to use to calculate dry
bushels (example: 15%-corn, 13%-soybeans). Typically, this value
is the same moisture your elevator uses to calculate the bushels for
which you are paid.
3 Repeat steps 1-2 and set DRY % for each grain type you will
harvest.
Setting Dry Lbs/Bu Use DRY LB/B to change the pounds/bushel value that the monitor uses to
calculate bushels.
Step Action
1 Press the GRAIN key until a grain type appears on the display and
use the bottom-left UP or DOWN ARROW keys to select a grain
type you will harvest.
Note: You must have a load displayed to change the grain type.
2 Press the GRAIN key until “xx DRY LB/B” appears on the display,
then use the bottom-left UP or DOWN ARROW keys to set the
correct value for the grain type.
Note: This value can be changed for all grain types except corn (56
lbs/bu), soybeans (60 lbs/bu), and wheat (60 lbs/bu).
3 Repeat steps 1-2 and set dry lbs/bu for each grain type you will use.
* * *