Ag Leader Yield Monitor 2000 Operators Manual - Manual (Page 23)

Yield Monitor 2000
Speed Setting
Ag Leader Technology
June 1997
2-19
Speed Setting The monitor can record its ground speed from three different sources:
•
Ground speed sensor on combine
•
Radar gun
•
GPS (only with Ag Leader Technology GPS 2000, Trimble AgGPS 120,
122 receivers, must have VTG data string)
The monitor has six different speed settings. The speed settings are set for
each load. With a load displayed press the DIST key until “SPD=” is
displayed. Use the bottom right UP or DOWN ARROW keys to select:
•
WHL (wheels)
•
TRK (tracks)
•
RAD (radar)
•
GPS/WHL
•
GPS/TRK
•
GPS/RAD
If you are getting ground speed from… Select
The combine speed sensor WHL
The combine speed sensor on combine tracks TRK
A radar gun RAD
Compatible GPS receiver and backup sensor is combine
speed sensor GPS/WHL
Compatible GPS receiver and backup sensor is combine
speed sensor on tracks GPS/TRK
Compatible GPS receiver and backup sensor is a radar gun GPS/RAD
Note: If you want to use a radar gun, contact Ag Leader Technology and
purchase a special adapter cable for your radar gun.
Since the speed setting is set for each load, the monitor will set the speed
setting of any newly created loads to the same setting as the previous load in
that field. Make sure that all the loads in the monitor are set to the correct
speed setting before you create new loads.