Ag Leader Yield Monitor 2000 Operators Manual - Manual (Page 153)

Yield Monitor 2000
Troubleshooting
Ag Leader Technology
June 1997 6-1
Introduction Use the procedures on the following pages to troubleshoot, calibration,
operation, and installation problems. If you cannot pinpoint the problem, call
Ag Leader Technology at 515-232-5363 (fax: 515-232-3595).
If you think you have a hardware failure, call Ag Leader Technology and
loaner or replacement hardware will be shipped to you immediately.
This section is formatted as follows:
Problem 1. Cause
Solution:
Subject Page
Bu/Ac Yield Too High or Low 6-3
Yield in Bu/Ac Always 0 6-6
0 Flow in Bu/Hr 6-6
Incorrect Acre Counting 6-8
Incorrect Moisture 6-10
Average and Instantaneous Yield Do Not Agree 6-12
Incorrect Grain Weight (lbs) 6-12
Elevator Speed is 0 or Erratic 6-17
Incorrect Distance and MPH 6-18
Incorrect Temperature Reading 6-20
Area Count Light Always On 6-20
Monitor Does Not Start 6-21
Monitor Does Not Function 6-22
Monitor Not Responding to Keys 6-23
Corrupt Main Memory 6-23
Monitor Has No Display 6-24
No GPS Signal 6-25
High Yield Reading After Stopping 6-26
Monitor Chirps While Harvesting 6-26
Card Too Small To Log 6-26
Display Not Visible at Night 6-27
Alarm Sounds Continuously 6-27
“Elevator Speed Changed” Message 6-27