Ag Leader Yield Monitor 2000 Operators Manual - Manual (Page 19)

Yield Monitor 2000
Settings Under SETUP Key
Ag Leader Technology
June 1997
2-15
Other Settings To set the remaining settings under the SETUP key, refer to the Yield
Monitor Initial Calibration Sheet in this section for the correct values.
Box Calibration Press the SETUP key until “xxx BOX CAL” appears on the display, then use
the top UP or DOWN ARROW keys to set the number equal to the Initial
Calibration Sheet if needed. The Box calibration number should have been
set correctly at the factory.
Voltage Calibration Press the SETUP key until “xxx VOLTAGE CAL” appears on the display,
then use the top UP or DOWN ARROW keys to set the number equal to the
number on the Initial Calibration Sheet if needed. The Voltage calibration
number should have been set correctly at the factory.
Sensor Calibration Press the SETUP key until “xxxx SENSOR CAL” appears on the display,
then use the top UP or DOWN ARROW keys to set the number equal to the
Initial Calibration Sheet if needed. The Sensor calibration number should
have been set correctly at the factory.
Note: If you replace the flow sensor, you must change this setting to the
value of the new sensor calibration number of the new flow sensor.
Scale Factor Press the SETUP key until “SCALE FACTOR=x.x” is displayed.
Press the top Up and DOWN ARROW key to change the scale factor to the
value on the Initial Calibration Sheet.
Important:
•
Never change the scale factor during harvest. Doing so will cause the
monitor to lose calibration accuracy and you will have to set the monitor
on different grain types and recalibrate every grain type.
•
If you have cleared the fields in the monitor, but have a good
calibration and will save the old calibration loads, do not adjust the
scale factor number, even if it is not set to the value on the initial
calibration sheet. If you do adjust the scale factor after saving the old
calibration loads, you will have to erase the old calibration loads and
enter new calibration loads for every grain type.
EL Pulse/Rev Press the SETUP key until “x EL PULSE/REV” appears on the display, then
use the top UP or DOWN ARROW keys to set the number equal to the
Initial Calibration Sheet if needed. EL Pulse/Rev should have been set
correctly at the factory.