Ag Leader Yield Monitor 2000 Operators Manual - Manual (Page 81)

Yield Monitor 2000
Field Operation Key Presses
Ag Leader Technology
June 1997
4-17
Acres and Distance
•
Press the AREA key until “xx.xx AC” appears on the display to see the
total area in acres.
•
Press the DIST key until “xxxxxx FT” appears on the display to see the
total feet traveled.
•
Press the FIELD key to display the field alone on the top line to see the
total acres or distance for a field only.
•
Press the LOAD key to display the field and load to see the total acres or
distance for a load only.
•
If you press the AREA key while the data load is displayed when you are
harvesting, you can see the area in acres being added.
Flow Press the FLOW key until “xxxx BU/HR” appears on the display to see the
harvest flow rate in bu/hr. If you are not harvesting, the flow rate is 0 bu/hr.
Speed
•
Press the SPEED key until “x.x MPH” appears on the display to see the
travel speed of the combine.
•
Press the SPEED key until “x.x AC/HR” appears on the display to see
the acres/hour at which you are harvesting.
•
Press the FLOW key until “xxx EL RPM” appears on the display to see
the clean grain elevator speed of the combine.
GPS Data Press the DIST key until “x.xxxxxx N” appears on the display and then press
it again until “x.xxxxxx E” appears on the display to see the latitude and
longitude change. These are the actual coordinates in degrees that the GPS
receiver sends to the monitor. They change as you travel through the field.
The last digit represents a distance of about 1/2 foot.
Press the DATE/TIME key until “xxxxx SEC” appears on the display to see
the GPS time. This is the GPS time that relates to the satellites that the GPS
receiver tracks.