Ag Leader Yield Monitor 2000 Operators Manual - Manual (Page 114)

Using a Radar Speed Sensor
Yield Monitor 2000
Ag Leader Technology
June 1997
4-48
Step Action
5 Connect the extension cable (if Dickey-john, integral cable) to the
four-pin round connector of the radar jumper cable.
6 Press the DIST key until “SPD=WHL or RAD or TRK” appears on
the display.
7 Set SPD=RAD on all loads created in the monitor but not yet used
for harvesting.
Note: You must change this setting for each load, one at a time.
8 Calibrate distance on a load with SPD=RAD, using the distance
calibration procedure outlined in the Calibration section.
* * *