Ag Leader Yield Monitor 2000 Operators Manual - Manual (Page 85)

Yield Monitor 2000
Swath Setting
Ag Leader Technology
June 1997
4-21
Partial Swath You can change to a partial swath while you are harvesting. Adjust the
cutting swath, not the head swath, to set a partial swath. To set the monitor
on a partial swath, do either of the following:
•
Reduce the number of cutting rows by pressing the # ROWS key
(reducing the cutting rows reduces the cutting swath)
•
Reduce the cutting swath by pressing the SWATH key.
Use the top DOWN ARROW key to change either one.
Recommendations:
•
For cutting platforms, set a partial swath by reducing the cutting swath.
Because the cutting swath reads in total feet, the swath is easier to
visualize on a cutting platform head.
•
For row crop heads, set a partial swath by reducing the cutting rows.
When the monitor is set to a partial swath (cutting swath is less than head
swath), it chirps every four seconds and displays “LESS THAN FULL
SWATH” to alert you that you are set on a partial swath. When you finish
harvesting a partial swath, you must set the cutting rows or cutting swath
back to the same value as the head rows or swath.
* * *