beautypg.com

Yield monitor 2000, Ag leader technology – Ag Leader Yield Monitor 2000 Operators Manual User Manual

Page 20

background image

Settings Under SETUP Key

Yield Monitor 2000

Ag Leader Technology

June 1997

2-16

Tooth Sprocket

Press the SETUP key until “x TOOTH SPROCKET” appears on the display,

then use the top UP or DOWN ARROW keys to set the number equal to the
Initial Calibration Sheet if needed. This number should have been set
correctly at the factory.

Note: This sprocket is at the top of the clean grain elevator and the elevator
paddles rotate around it.

TI, T2, and T3

Press the SETUP key three additional times until “T1=10,” “T2=5,” and

“T3=8” appear on the display, then check these numbers against the Initial
Calibration Sheet. If they are not set correctly, change them using the top UP
or DOWN ARROW keys. These numbers should have been set correctly at
the factory.

* * *

See also other documents in the category Ag Leader Equipment: