HP Hitachi Dynamic Link Manager Software - Manual (Page 73)

2. HDLM Functions
49
#1
The severity levels are as follows:
3: Error, 4: Warning, 6: Informational
#2
If you use Ctrl + C to cancel the
DLMgetras
utility for collecting HDLM error
information, audit log data indicating that the
DLMgetras
utility has terminated
will not be output.
2.12.2 Requirements for Outputting Audit Log Data
HDLM can output audit log data when all of the following conditions are satisfied:
• The
syslog
daemon is active.
• The output of audit log data has been enabled by using the HDLM command's
set
operation.
However, audit log data might still be output regardless of the above conditions if, for
example, an HDLM utility is executed from external media.
#
#:
The following audit log data is output:
• Categories:
StartStop
,
Authentication
, and
ConfigurationAccess
• Severity: 6 (Critical, Error, Warning, or Informational)
• Destination: syslog (facility value:
user
)
Notes:
Processing of the
dlmsetopt -inqr
command was successful.
6 KAPL150
56-I
Processing of the
dlmsetopt -inqr
command failed.
3 KAPL150
57-E
Processing of the
dlmupdatesysinit
command was successful.
6 KAPL150
58-I
Processing of the
dlmupdatesysinit
command failed.
3 KAPL150
59-E
Category Explanation Audit event Severity
#1
Message
ID