HP Hitachi Dynamic Link Manager Software - Manual (Page 304)

3. Creating an HDLM Environment
280
This example shows how to specify the audit log facility:
# /opt/DynamicLinkManager/bin/dlnkmgr set -audfac local0
3.18.3 Checking the Updated Settings
This chapter describes steps involved in how to check the new settings by using the
dlnkmgr
command's
set
operation after the new settings are applied.
When you some these settings, you can display information about all of HDLM
function settings. The following is an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -sfunc
HDLM Version :
x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster :
Elog Level : 2
Elog File Size(KB) : 1000
Number Of Elog Files : 5
Trace Level : 1
Trace File Size(KB) : 2000
Number Of Trace Files : 10
Path Health Checking : on(10)
Auto Failback : on(10)
Reservation Status :
Intermittent Error Monitor : on(2/20)
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
#
After you have set up the collection of audit log data, use the following command to
make sure that the setting has been specified correctly:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -audlog
Audit Log : on(6)
Audit Log Category : all
Audit Log Facility : local0
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time =
yyyy
/
mm
/
dd hh
:
mm
:
ss
#