HP Hitachi Dynamic Link Manager Software - Manual (Page 374)

4. HDLM Operation
350
4.3.11 Viewing HDLM Component Information
This section explains how to display HDLM component information.
To display HDLM component information, execute the
dlnkmgr
command's
view
operation with the
-sys
parameter specified. The following is an example of
executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys
HDLM Version :
x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster :
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Reservation Status :
Intermittent Error Monitor : off
HDLM Manager Ver WakeupTime
Alive
x.x.x-xx
yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive
x.x.x-xx
yyyy/mm/dd hh:mm:ss 1000
HDLM Driver Ver WakeupTime
Alive
x.x.x-xx
yyyy/mm/dd hh:mm:ss
LicenseType Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
#
Among the displayed items,
HDLM Manager
,
HDLM Alert Driver
, and
HDLM Driver
indicate the HDLM component information.
Also, you can view information for each HDLM component. Execute the
dlnkmgr
command's
view
operation with the
-sys
and subsequent parameter specified. The
following is an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -msrv
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -adrv
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -pdrv