18 setting up hdlm, 1 checking the current settings, 2 setting up the hdlm functions – HP Hitachi Dynamic Link Manager Software User Manual
Page 295

3. Creating an HDLM Environment
271
3.18 Setting Up HDLM
HDLM includes functions like the load balancing function, the automatic failback
function, the error logging function, the audit logging function, etc. You can set up
these functions by using the
dlnkmgr
command's
set
operation.
3.18.1 Checking the Current Settings
Check the current settings by executing the following command to set the HDLM
functionality by using the
dlnkmgr
command's
view
operation.
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -sfunc
HDLM Version :
x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster :
Elog Level : 3
Elog File Size(KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Reservation Status :
Intermittent Error Monitor : off
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
#
To check the current audit log settings, execute the following command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -audlog
Audit Log : off
Audit Log Category : -
Audit Log Facility : -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time =
yyyy
/
mm
/
dd
hh
:
mm
:
ss
#
3.18.2 Setting Up the HDLM Functions
The recommended and default values for each HDLM function is shown below in
Table 3-57: The Recommended and Default Values of Each Function.