HP Hitachi Dynamic Link Manager Software - Manual (Page 160)

3. Creating an HDLM Environment
136
configuration, memory might become insufficient due to the HAL daemon
#
. In
this case, the host will not respond.
To avoid this, stop the HAL daemon when executing the
dlmcfgmgr
utility. The
following procedure shows how to stop the HAL daemon.
#
The HAL daemon detects hardware configurations changes, for example,
when a USB device or CD-ROM is inserted.
To stop the HAL daemon:
1.
Check the status of the HAL daemon.
Execute the
/sbin/service
command to check the HAL daemon status. If
the daemon is running,
running
will appear.
# /sbin/service haldaemon status
If the daemon is not running,
stopped
will appear.
2. Check the result of step 1. If the HAL daemon is running, stop the daemon.
Execute the
/sbin/service
command to stop the HAL daemon. Note that
it might take a while to stop the daemon completely.
# /sbin/service haldaemon stop
3. Make sure that the HAL daemon is stopped.
Execute the
/sbin/service
command to make sure that the HAL daemon
is not running.
# /sbin/service haldaemon status
4. Execute the dlmcfgmgr utility (
dlmcfgmgr -r or dlmcfgmgr -i
) to
configure the HDLM device.
# /sbin/dlmcfgmgr -r
or