HP Hitachi Dynamic Link Manager Software - Manual (Page 192)

3. Creating an HDLM Environment
168
Edit the installation information settings file based on your desired settings.
Specify any settings that are not specified in this file after installing HDLM, as
necessary.
To use the sample file, copy it from the DVD-ROM to a directory on the hard disk.
Note that the sample file name can be changed to any name.
The following shows an installation execution example for when the DVD-ROM
mount point is
/media/cdrom
.
# cp -p /media/cdrom/HDLM_Linux/config/
sample_installhdlm.conf /
any-directory
/
any-file-name
For details about how to edit the installation information settings file, which is
used by the
installhdlm
utility, see 7.10.3 Editing an Installation-Information
Settings File.
6. Perform the installation.
Execute
installux.sh
or the
installhdlm
utility stored on the HDLM
DVD-ROM to start installation.
The following shows an installation execution example for when the DVD-ROM
mount point is
/media/cdrom
.
• When executing
installux.sh
# /media/cdrom/installux.sh -f /
any-directory
/
installation-information-settings-file
• When executing the
installhdlm
utility
# /media/cdrom/HDLM_Linux/installhdlm -f /
any-directory
/
installation-information-settings-file
Note that, if you edited the installation information settings file in step 5 so that
the host is restarted, the host is automatically restarted.
7. Make sure that HDLM is installed.
Execute the following command to display detailed information about the
installed package.
# rpm -qi HDLM