HP Hitachi Dynamic Link Manager Software - Manual (Page 339)

3. Creating an HDLM Environment
315
Figure 3-41: Example of Executing the dlmcfgmgr Utility with the -v Parameter
Specified
Figure 3-42: Example of Executing the dlmcfgmgr Utility with the -v and -udev
Parameters Specified
The
HDevName
,
Device
, and
Udev
columns display HDLM devices, SCSI
devices, and
udev
names, respectively.
4. Edit the
/etc/fstab
file.
Change the mount points for the HDLM management-target devices that you
checked in step 2 from the HDLM device to the SCSI device. Comment out the
existing HDLM device specification by placing a hash mark (
#
) at the beginning
of each line, and then add the SCSI device specification as shown below, based
on the correspondence between the HDLM device and SCSI device as checked in
step 3.
:
:
#/dev/sddlmaa2 / ext2 defaults 1 1
/dev/sda2 / ext2 defaults 1 1
:
:
For Red Hat Enterprise Linux 6, a block device name starting with
UUID=
instead
of a SCSI device name can be specified. If that is the case, go to step 5.
If you are using SUSE LINUX Enterprise Server 10, you can specify the device
name (
udev
name) in the
/dev/disk
directory instead of the SCSI device. In
this case, go to step 5.
If LVM2 is used in cases other than above, go to step 6. If LVM2 is not used, go