HP Hitachi Dynamic Link Manager Software - Manual (Page 616)

8. Messages
592
An error occurred during I/O of a file that
installhdlm
uses.
aa...aa: Error number that indicates the executed processing (decimal (base-10)
number)
bb...bb: Return value of the executed processing (decimal (base-10) number)
Action
Make sure that sufficient unused capacity exists for the
/tmp
directory. If the
capacity is insufficient, allocate the required amount of capacity, and then retry
the operation. For details about the required unused capacity. For details about the
required unused capacity, see (2) Disk Requirements in 3.1.11 Memory and Disk
Capacity Requirements.
KAPL09217-E
An error occurred during reading of the installation information
settings file. Error Code =
aa...aa
,
bb...bb
Details
An error occurred while reading the installation information settings file.
aa...aa: Error number (decimal number) that specifies the executed processing
bb...bb: Return value (decimal number) of the executed processing
Action
If the error code is
9001
,
-1
:
You do not have read permissions for the installation information settings
file. Make sure that you have access permissions.
If any other error code is output:
Contact your HDLM vendor or the maintenance company if there is a
maintenance contract for HDLM.
KAPL09218-E
aa...aa
cannot be executed.
Details
A utility or command that
installhdlm
uses was not in the correct location, or
you do not have a required permission.
aa...aa:
installhdlm_analysis
,
dlmcfgmgr
, or
dlnkmgr
Action
If aa...aa is
dlnkmgr
:
The correct location of
dlnkmgr
is
/opt/DynamicLinkManager/bin
. If
dlnkmgr
was not in the correct location, or you did not have a required