HP Hitachi Dynamic Link Manager Software - Manual (Page 428)

6. Command Reference
404
6.4 offline (Places Paths Offline)
The
dlnkmgr
command's
offline
operation places online paths offline. Specify the
paths to be placed offline by specifying an HBA port, CHA port, or single path. Instead
of specifying a path, you can also specify a SCSI device name.
There must always be at least one online path accessing each LU.
Placing too many paths offline might prevent paths from being able to switch if an
error occurs. Before placing a path offline, use the
view
operation to check how many
online paths remain. For details about the
view
operation, see 6.7 view (Displays
Information).
6.4.1 Format
(1) To place paths offline
/opt/DynamicLinkManager/bin/dlnkmgr offline
[-path]
{-hba
host-port-number.bus-number
|-cha -pathid
AutoPATH_ID
|-pathid
AutoPATH_ID
|-device
SCSI-device-name
}
[-s]
(2) To Display the Format of the offline Operation
/opt/DynamicLinkManager/bin/dlnkmgr offline -help
6.4.2 Parameters
(1) To place paths Offline
-path
Indicates that the target of the operation is a path managed by HDLM.
This parameter is optional because
offline
is always used for paths, so it is
assumed.
Make sure that you specify the paths to be taken offline by using the
-hba
,
-cha
,
-pathid
, or
-device
parameter.
-hba
host-port-number.bus-number
Use this parameter to place offline, at one time, all the paths that pass through a
specific HBA port. The command will place offline all the paths connected to the