HP Hitachi Dynamic Link Manager Software - Manual (Page 223)

3. Creating an HDLM Environment
199
multipath=off
initrd /initrd-2.6.16.60-0.54.5-smp
multipath=off
is set in the underlined section.
3. Check whether the definition in the
/etc/fstab
file contains
LABEL
.
Check the contents of the
/etc/fstab
file.
Figure 3-8: Example Content of /etc/fstab file When using LVM2 shows example
content of
/etc/fstab
file.
Figure 3-8: Example Content of /etc/fstab file When using LVM2
LABEL
is set in the shaded portion.
This example assumes that IA32 uses
GRUB
as the boot loader. When you use IPF
that uses
ELILO
as the boot loader, the mount point is displayed as
/boot/efi
instead of
/boot
(in the line where
/boot
is coded), and the file system type is
displayed as
vfat
instead of
ext3
.
If
LABEL
is not used in the
/etc/fstab
file, go to step 10 and install HDLM. If
LABEL
is used in the
/etc/fstab
file, perform steps 4 to 8 to check the mounted
file system, and then remove the
LABEL
setting.
4. Execute the
mount
command to check the mounted file system.
Check the correspondence between the SCSI device and
LABEL
that you checked
in steps 3. You will need this information to remove the
LABEL
setting.
Figure 3-9: Example of Executing the mount Command shows an example of
executing the
mount
command.