HP Hitachi Dynamic Link Manager Software - Manual (Page 301)

3. Creating an HDLM Environment
277
# /opt/DynamicLinkManager/bin/dlnkmgr set -elfs 1000
Specify the size of the error log file in KB.
(8) Setting the Number of Error Log Files
The number of the error log files (the HDLM manager log (
dlmmgr
n
.log
(n indicates
a file number from
1
to
16
))) can be set.
You can specify a value from 2 to 16 for the number of HDLM manager log files.
By specifying both the log file size and the number of log files, you can collect up to
32000000KB (approximately 30GB) of error logs.
The following is an example of using a command to set the number of error log files.
# /opt/DynamicLinkManager/bin/dlnkmgr set -elfn 5
Specify the number of error log files by a number.
(9) Setting the Trace File Size
Trace files for which a trace file size can be set are
hdlmtr
n
.log
(n indicates a file
number from
1
to
64
). The length of a trace file is fixed, regardless of how much trace
information is actually in the file.
For the trace file size, you can specify a value (in kilobytes) from 100 to 16000. If you
specify a value smaller than the setting value, the KAPL01097-W message will be
displayed to confirm the execution, and the trace file will be temporarily deleted.
When all the trace files become full, the oldest file is overwritten with any new trace
data.
By specifying both the trace file size and the number of trace files, you can collect up
to 1024000 KB of trace data.
The following is an example of using a command to set the trace file size:
# /opt/DynamicLinkManager/bin/dlnkmgr set -systfs 2000
Specify the size of the trace file in KB.
(10) Setting the Number of Trace Files
Trace files for which the number of files can be set are
hdlmtr
n
.log
(n indicates a
file number from
1
to
64
).
For the number of trace files, you can specify a value from 2 to 64. If you specify a
value smaller than the value that has already been specified, the KAPL01097-W