HP Hitachi Dynamic Link Manager Software - Manual (Page 544)

7. Utility Reference
520
You can specify this key only in the following cases:
• For a new installation:
When
on
is specified for the
auto_failback
key in the installation
information settings file
• For an upgrade installation or re-installation:
When
on
is specified for the
auto_failback
key in the installation
information settings file, or when automatic failback is enabled in the
installation pre-settings
The following shows an example of an edited installation information settings file.
[INSTALLATION_SETTINGS]
licensekeyfile=/var/tmp/hdlm_license
licensekey=/etc/opt/DynamicLinkManager/dlm.lic_key
driver_config=y
restart=n
[ENVIRONMENT_SETTINGS]
load_balance=on
load_balance_type=exlio
load_balance_same_path_use_times=32
error_log_level=3
error_log_size=9900
error_log_number=2
trace_level=0
trace_file_size=1000
trace_file_number=4
path_health_check=on
path_health_check_interval=30
auto_failback=on
auto_failback_interval=1
# intermittent_error_monitor=off
# intermittent_error_monitor_interval=210
# intermittent_error_monitor_number=3