HP Hitachi Dynamic Link Manager Software - Manual (Page 205)

3. Creating an HDLM Environment
181
:
:
title XEN
root (hd0,1)
kernel /boot/xen.gz
module /boot/vmlinuz-2.6.16.60-0.21-xen root=/dev/disk/
by-id/scsi-1HITACHI_D60H03750027-part2 vga=0x31a resume=/
dev/sda1 splash=silent showopts
module /boot/initrd-2.6.16.60-0.21-xen
If
LABEL
or the device name (
udev
name) was not used in step 3 and step 4,
proceed to step 17 and install a new instance of HDLM.
If the device name (
udev
name) has been specified, replace
LABEL
with the
device name (
udev
name) when reading the steps below.
5. Execute the
mount
command to check the mounted file system.
Check the correspondence between the SCSI device and
LABEL
that you checked
in steps 3 and 4. You will need this information to remove the
LABEL
setting.
# mount
/dev/sda2 on / type ext2 (rw)
:
:
/dev/sda1 on /boot type ext2 (rw)
/dev/sda4 on /tmp type ext2 (rw)
/dev/sda5 on /var type ext2 (rw)
/dev/sda6 on /usr type ext2 (rw)
none on /dev/shm type tmpfs (rw)
Check the underlined section.
6. If Red Hat Enterprise Linux, SUSE LINUX Enterprise Server 10, or SUSE
LINUX Enterprise Server 11 is being used, check the SCSI device name in the
/
proc/swaps
file.
The SCSI device name is displayed in the
Filename
column.
7. If the block device name or the
udev
name was specified in steps 3 and 4, execute
the following commands to check the SCSI device:
• For Red Hat Enterprise Linux 6
Execute the
udevadm
command. Specify the block device name for
-n
.