HP Hitachi Dynamic Link Manager Software - Manual (Page 463)

6. Command Reference
439
-lbpathusetimes
Times Same Path Was Used : 32
KAPL01001-I The HDLM command completed normally. Operation
name = view, completion time = yyyy/mm/dd hh:mm:ss
#
(2) To display path information
When displaying path information, if you specify either the
-item
or
-c
parameter
and also specify the
-path
parameter, you can select the items to display and display
a summary of path information. This section describes each parameter, path
information and displayed items.
To display path information
-path
When you specify the
-path
parameter and do not specify either the
-c
or
-item
parameter, the information will be displayed about the HDLM managed paths
without abbreviating or selecting items.
In the sub-parameters (following
-path
), you can filter the paths to be listed
using
-hdev
and sort the list using
-srt
. When you omit both parameters, the
command displays information for all the paths in order of increasing
AutoPATH_IDs.
For details on what is displayed in each item, see Table 6-12: Path Information.
AutoPATH_IDs displayed by the
-path
parameter depend on the sequence in
which HDLM detects the paths after a host is started up. Because of this, make
sure that you use the path name
PathName
to identify a path.
The sub-parameters are as follows:
-hdev
host-device-name
Displays information only for the paths accessing the specified host device.
Specify the name of the logical device file (minus the partition number),
/
dev/sddlm
[aa-pap], for the HDLM device. For details on logical device
files for HDLM devices, see 2.6 Logical Device Files for HDLM Devices.
The host-device-name string is case-sensitive.
-stname
Use this parameter to display the model ID of the storage system in the
product ID element of the
DskName
field. When this parameter is omitted,
the command displays the product ID or emulation type of the storage system
instead.
For details about the information displayed for product IDs, see