HP Hitachi Dynamic Link Manager Software - Manual (Page 346)

3. Creating an HDLM Environment
322
kernel /vmlinuz-2.6.9-11.EL ro rhgb quiet
initrd /initrd-hdlm-2.6.9-11.EL.gz
title Red Hat Enterprise Linux AS (2.6.9-11.EL)
root (hd1,0)
kernel /vmlinuz-2.6.9-11.EL ro root=/dev/VolGroup00/
LogVol00 rhgb quiet
# initrd /initrd-hdlm-2.6.9-11.EL.img
initrd /initrd-2.6.9-11.EL.img
8. Copy the configuration that was used for startup from the HDLM device.
9. Assign a name to the copied configuration.
You can assign any name that indicates that the configuration is used for
specifying the SCSI device.
Change
label
if the boot loader is LILO, or ELILO running on an IPF host. If
LILO is the boot loader, you must then execute
/sbin/lilo
command to
activate the new setting.
Change
title
if you will use GRUB as the boot loader.
10. In
root
, specify the SCSI device you checked in step 3.
If you are using a kernel that supports Xen on SUSE LINUX Enterprise Server
10, add the root device by using the definition conventions for the boot loader
configuration file.
When LVM2 is used, specify
root
as the name of the device mounted to
/
in the
/etc/fstab
file.
If LVM2 is not used in Red Hat Enterprise Linux 6, a block device name starting
with
UUID=
can be used. To check the correspondence between a SCSI device and
the block device name starting with
UUID=
, see step 5.
If LVM2 is not used in SUSE LINUX Enterprise Server 10, you can also use the
device name (
udev
name) in the
/dev/disk
directory. To check the
correspondence between the SCSI devices and the device name (
udev
name) in
the
/dev/disk
directory, see step 5.
11. In
initrd
, specify the initial RAM disk image file for the SCSI device.
If you are using a kernel that supports Xen on SUSE LINUX Enterprise Server
10, change the
initrd
file name specified in
module
to the initial RAM disk