HP Hitachi Dynamic Link Manager Software - Manual (Page 433)

6. Command Reference
409
6.5 online (Places Paths Online)
The
dlnkmgr
command's
online
operation places offline paths online. Specify the
paths to be placed online by specifying an HBA port, CHA port, or single path. Instead
of specifying a path, you can also specify a SCSI device name.
6.5.1 Format
(1) To place paths Online
/opt/DynamicLinkManager/bin/dlnkmgr online
[-path]
[-hba
host-port-number.bus-number
|-cha -pathid
AutoPATH_ID
|-pathid
AutoPATH_ID
|-device
SCSI-device-name
]
[-s]
(2) To Display the Format of the Online Operation
/opt/DynamicLinkManager/bin/dlnkmgr online -help
6.5.2 Parameters
(1) To place paths Online
-path
Indicates that the target of the operation is a path managed by HDLM.
This parameter is optional because
online
is always used for paths, so it is
assumed.
Make sure that you specify the path to be taken online by using the
-hba
,
-cha
,
-pathid
, or
-device
parameter. If you do not specify any of these parameters,
the command will place all the offline paths online. If there is a path that cannot
be placed online, a message asking whether you would like to continue processing
will be displayed. To ignore the offline path that cannot be placed online and to
continue processing, enter
y
. To stop the processing, enter
n
.
-hba
host-port-number.bus-number
Use this parameter to place online, at one time, all the paths that pass through a
specific HBA port. The command will place online all the paths connected to the
HBA port that has the specified host port number and bus number.