HP Hitachi Dynamic Link Manager Software - Manual (Page 348)

3. Creating an HDLM Environment
324
Figure 3-44: Example of Executing the mount Command When the Boot
Loader Is LILO or GRUB
• When the boot loader is ELILO running on an IPF host
Figure 3-45: Example of Executing the mount Command When the Boot
Loader Is ELILO shows an example of executing the
mount
command.
Figure 3-45: Example of Executing the mount Command When the Boot
Loader Is ELILO
Refer to the
/proc/swaps
file to make sure that the specified SCSI device name
is displayed in the
Filename
column.
Go to step 18.
16. Update the information about the volume group.
Execute the following command to update the information about the volume
group.
# vgscan
Reading all physical volumes. This may take a while...
Found volume group "VolGroup00" using metadata type lvm2
17. Check the relationship between the volume group and HDLM devices.
Execute the following command to make sure that the physical volumes that make
up the volume group are not HDLM devices.