HP Hitachi Dynamic Link Manager Software - Manual (Page 186)

3. Creating an HDLM Environment
162
# /media/cdrom/installux.sh
• When executing the
installhdlm
utility
# /media/cdrom/HDLM_Linux/installhdlm
6. The KAPL09093-I message is displayed to confirm that you want to perform an
upgrade installation. Check the HDLM version, and if it is correct, enter
y
.
7. Make sure that HDLM is installed.
Execute the following command to display detailed information about the
installed package.
# rpm -qi HDLM
Name : HDLM
Version :
x.x.x.x.xxx
Release :
xx
:
If
HDLM Version
is x.x.x.x.xxx, the installed version of HDLM is correct.
x.x.x.x.xxx indicates the HDLM version that was installed.
8. If IP-SAN is used for the connection between the host and the storage system,
change
iscsi_boot=n
, written in the
/etc/opt/DynamicLinkManager/
hdlm.conf
file, to
iscsi_boot=y
.
9. When you want to set the HDLM driver options, run the
dlmsetopt
utility for
setting HDLM driver option.
For details on this utility, see 7.6 dlmsetopt Utility for Setting HDLM Driver
Options.
If you performed this step, go to step 12.
10. When you want to install HDLM without restarting the host, go to step 11. When
you want to install HDLM with restarting the host, then go to step 12.
11. Execute the
dlmstart
utility for starting HDLM.
For details, see 7.7 dlmstart Utility for Starting HDLM.
12. Add
/opt/DynamicLinkManager/bin
in the environment variable
PATH
in
the environment setup file for the shell used by the root user.
Add the following code to the
PATH
environment variable in the environment