HP Hitachi Dynamic Link Manager Software - Manual (Page 682)

8. Messages
658
KAPL12563-E
An attempt to create a directory has failed. Directory =
aa...aa
Details
aa...aa: Directory that an attempt was made to create
Action
Make sure there is enough free disk capacity, and then re-execute the utility for
setting HDLM driver option (
dlmsetopt
).
Delete any unnecessary files in the file system, and then re-execute the
dlmsetopt
utility.
KAPL12564-E
An attempt to back up a file has failed. File name =
aa...aa
Details
aa...aa: Backup file name
Action
Make sure there is enough free disk capacity, and then re-execute the utility for
setting HDLM driver option (
dlmsetopt
).
KAPL12565-E
Could not modify file. File name =
aa...aa
Details
aa...aa: Name of file to be updated
Action
Make sure there is enough free disk capacity, and then re-execute the utility for
setting HDLM driver option (
dlmsetopt
). If this message still appears, stop any
unnecessary processes, and then re-execute the
dlmsetopt
utility.
KAPL12566-E
The utility for setting HDLM driver option was executed and ended
abnormally last time.
Action
Compare the contents of the
/etc/modprobe.conf
file and the
/etc/opt/
DynamicLinkManager/DLMSETOPT/modprobe.conf
file. According to the
result, perform the following procedures:
The
/etc/opt/DynamicLinkManager/DLMSETOPT/modprobe.conf
file
was copied for backup by HDLM before the utility for setting HDLM driver
option (
dlmsetopt
) is to be executed. If Red Hat Enterprise Linux 6 is being
used,
/etc/modprobe.conf
must be read as
/etc/modprobe.d/