HP Hitachi Dynamic Link Manager Software - Manual (Page 377)

4. HDLM Operation
353
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -msrv
HDLM Manager Ver WakeupTime
Alive
x.x.x-xx
yyyy/mm/dd hh:mm:ss
KAPL01001-I The HDLM command completed normally. operation
name = view, completion time = yyyy/mm/dd hh:mm:ss
#
When the
HDLM Manager
column shows
Alive
, the HDLM manager is active.
Use a script for confirmation:
Execute the following command to confirm that the HDLM manager is active:
# /etc/init.d/DLMManager status
dlmmgr (pid 14889 14886 14884 14880) is running...
Note
If an error occurs, the execution results of the
dlnkmgr
command's
view
operation might be different from those of the
DLMManager status
command.
In this case, see the execution results of the
dlnkmgr
command.
4.4.2 Stopping the HDLM Manager
To stop the HDLM manager, log in to Linux as a user with root permissions, and then
execute the following command:
# /etc/init.d/DLMManager stop
Stopping DLMManager: [ OK ]
Lower case characters can be used for the command name (
dlmmanager
).
# /etc/init.d/dlmmanager stop
Stopping DLMManager: [ OK ]
The stop script that was set up during HDLM installation runs, and stops the HDLM
manager.
Use one of the following procedures to confirm that the HDLM manager has stopped:
Use the
dlnkmgr
command's
view
operation:
Execute the following command.
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -msrv
HDLM Manager Ver WakeupTime
Dead
KAPL01001-I The HDLM command completed normally. operation
name = view, completion time = yyyy/mm/dd hh:mm:ss