HP Hitachi Dynamic Link Manager Software - Manual (Page 721)

B. Troubleshooting Products That Use the Weak-Modules Script
697
B. Troubleshooting Products That Use the Weak-Modules Script
If you use an HDLM device as a boot disk in Red Hat Enterprise Linux 5 and attempt
to install or uninstall a product that uses the weak-modules script, the following
message might be output, and installation or uninstallation of that product might fail:
grubby fatal error: unable to find a suitable template
Therefore, when using an HDLM device as a book disk in Red Hat Enterprise Linux
5, execute the following commands before installing or uninstalling a product that uses
the weak-modules script:
Before installation
# rpm -qp
package-file-name-of-product #
--scripts | grep
weak-modules
Before uninstallation
# rpm -q
package-file-name-of-product #
--scripts | grep
weak-modules
#
If you do not know the package file name of the product that uses the
weak-modules script, perform the procedures described in B.1 Installing
Products That Use the Weak-Modules Script or B.2 Uninstalling Products That
Use the Weak-Modules Script.
If no message is output after executing the above
rpm
command, the product does not
use the weak-modules script. You can install or uninstall the product as usual.
If a message is output, the product uses the weak-modules script. Perform the
procedures described in B.1 Installing Products That Use the Weak-Modules Script or
B.2 Uninstalling Products That Use the Weak-Modules Script.
B.1 Installing Products That Use the Weak-Modules Script
To install a product that uses the weak-modules script:
1.
Determine which device specified in the
/etc/fstab
file is indicated as the root
directory (
/
).
In each of the following examples, the underlined part indicates the device for the