HP Hitachi Dynamic Link Manager Software - Manual (Page 133)

3. Creating an HDLM Environment
109
• HotPlug
• SystemManager linkage
Note that HDLM cannot use the functions provided by ServerConductor/
DeploymentManager other than the following:
• Backup and restoration
• BIOS/firmware updating
For details on the functions provided by ServerConductor/DeploymentManager, see
the manual ServerConductor/DeploymentManager User's Guide.
3.1.5 Related Products When Using Red Hat Enterprise Linux 6
The following describes related products when Red Hat Enterprise Linux 6 is used.
(1) Cluster Software Supported by HDLM (If an FC-SAN Is Used)
When you use HDLM in a cluster configuration, you must install the same version of
HDLM on all the nodes that comprise the cluster. If different versions of HDLM are
installed, the cluster system may not operate correctly. If the
HDLM Version
and
Service Pack Version
, which are displayed by executing the following command,
are the same, the versions of HDLM are the same:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys
Use RHCM to build a cluster configuration.
(2) Volume Managers Supported by HDLM
Table 3-28: Volume Managers When Using Red Hat Enterprise Linux 6 lists and
describes the related programs when using a volume manager.
Table 3-28: Volume Managers When Using Red Hat Enterprise Linux 6
(3) File Systems Supported by HDLM
Table 3-29: Supported File Systems When Using Red Hat Enterprise Linux 6 lists and
describes the related programs when using the file system.
Kernel architecture Kernel Volume manager
IA32 2.6.32-71.el6.i686 LVM2.02.72-8.el6
EM64T/AMD64 2.6.32-71.el6.x86_64