HP Hitachi Dynamic Link Manager Software - Manual (Page 338)

3. Creating an HDLM Environment
314
2. Make sure that the HDLM device is defined in the
/etc/fstab
file.
Make sure that the mount points for the following HDLM management-target
devices are defined so that the HDLM device will be mounted:
• When
ELILO
is used as the boot loader:
Root directory (
/
),
/boot/efi
,
/tmp
,
/usr
,
/var
,
swap
• When
GRUB
is used as the boot loader:
Root directory (
/
),
/boot
,
/tmp
,
/usr
,
/var
,
swap
• When
LILO
is used as the boot loader:
Root directory (
/
),
/tmp
,
/usr
,
/var
,
swap
• When LVM2 is used:
/boot
The following shows an example of the
/etc/fstab
file:
:
:
/dev/sddlmaa2 / ext2 defaults 1 1
:
:
3. Execute the HDLM-configuration definition utility (
dlmcfgmgr
) with the
-v
parameter specified to check the correspondence between the HDLM device and
the SCSI device.
If the SCSI device name has been changed by using the
udev
function, specify
the
-udev
parameter also.
Figure 3-41: Example of Executing the dlmcfgmgr Utility with the -v Parameter
Specified shows an example of executing the
dlmcfgmgr
utility with the
-v
parameter specified. Figure 3-42: Example of Executing the dlmcfgmgr Utility
with the -v and -udev Parameters Specified shows an example of executing the
dlmcfgmgr
utility with the
-v
and
-udev
parameters specified.