Seed Hawk Raven 2012 - Manual (Page 94)

Chapter 5
82 Seed Hawk® Viper Pro™ Installation & Operation Manual
Tank Level
The estimated level of product remaining in a liquid tank is displayed for products controlled by product nodes
4 or 5.
Touch within the Application Rates area to display the Application Control screen.
Use the on-screen keypad on the Application Control screen to enter a target rate and rate bump (-/+) value for
each product.
Note:
If the product switch is in the off position, the product name, target rate, and rate bump (-/+) will
display in grey (product 5 shown above). To modify settings for the product, toggle the product
switch to the Man (manual) or Auto (automatic) position.
Rate Bump (-/+)
The rate bump feature allows the operator to raise or lower the target rate using the INC/DEC switch on the
Seed Hawk switch box.
To use the rate bump feature:
1. Enter a value in the “Rate -/+” field for the desired products. This is the value by which the target rate will be
adjusted each time the INC/DEC switch is toggled.
2. Select the “Inc/Dec Switch” option for the products to be affected by the INC/DEC switch.
3. Touch the OK button to accept the programmed values and settings and return to the main screen.
4. Set the product switches to Auto.
5. Toggle the INC/DEC switch to increase or decrease the target rate of the selected products
Note:
For products set to Manual control mode, hold the INC/DEC switch to manually raise or lower the
target rate.