Seed Hawk Raven 2012 - Manual (Page 175)

8
Manual No. 016-3001-003 163
Advanced Settings and Features
Lightbar Guidance
Lightbar guidance features of the Viper Pro may be used to display guidance information on the Viper Pro
touch screen or to send guidance information to an external Raven lightbar connected to the auxiliary comm
port connector on the auxiliary interface cable. The Lightbar Setup screen offers the ability to quickly configure
the Viper Pro for either, or both, of these lightbar guidance options.
The Viper Pro may also forward guidance information to an optional Raven SmarTrax or SmartSteer
automated steering system connected to the guidance system.
Note:
To use the lightbar features of the field computer, a receiver capable of sending DGPS messages
at a minimum of 5 Hz must be connected to the Viper Pro.
1. To configure the lightbar guidance features from the Viper Pro, touch Menu, then Setup, Lightbar. The
Lightbar Setup screen displays.
2. Enable the desired lightbar options:
On-Screen Lightbar. Enable this option to display a lightbar at the top of the Viper Pro touch screen while
guidance is enabled during an active job. The on-screen lightbar will be displayed regardless of which tab is
active during the job.
External Lightbar. Enable this option to allow the Viper Pro to display guidance information on an external
Raven lightbar.
Send Guidance Message. Enable this option to send guidance messages from the Viper Pro to an optional
Raven SmarTrax or SmartSteer automated steering system.