Seed Hawk Raven 2012 - Manual (Page 153)

8
Manual No. 016-3001-003 141
Advanced Settings and Features
Reverse Sense. The reverse sense feature enables the field computer to detect when the vehicle is backing
up. With the reverse sensing feature turned off, the Viper Pro will always display any vehicle motion in the
forward direction.
Touch the Rev Sense button to display the Reverse Sense screen. Review the on-screen feature description
and select the desired mode of operation. When the Rev Sense feature is enabled, the field computer will
prompt the operator for the direction of travel each time the field computer is powered up.
While travelling at least 2 mph [3.2 km/h], select the current direction of travel to calibrate the Viper Pro for
automatic reverse detection. This feature may be helpful when backing into corners with the SCT feature
enabled. Touch the For(ward) or Rev(erse) button to manually select the direction of travel.
Course Over Ground (COG) Filter. The course over ground filter may be used to smooth the reported GPS
course displayed in the map area on the Viper Pro field computer. Touch the COG Filter button to display the
Course Over Ground Filter Selection screen. Review the feature description on the display and select the
appropriate filtering level.
View Data. Select the View Data button to view “raw” GPS data coming from the DGPS receiver into the Viper
Pro field computer via the ‘GPS Receiver/DGPS’ port on the main interface or chassis interface cable.
SmarTrax Settings Screens
If an optional SmarTrax or SmartSteer system is detected on the CANbus, the status of the system will be
displayed on the main screen.
If the SmarTrax system is engaged, the steering status display above the Menu button will show a green
steering wheel with the ‘A’ as shown in the image above. When the SmarTrax system is disengaged, the
steering wheel will be grey and no A will appear.
Note:
Refer to the SmarTrax or SmartSteer Calibration and Operation Manual for detailed calibration and
operation information.