Seed Hawk Raven 2012 - Manual (Page 251)

Manual No. 016-3001-003 239
3. Touch a boom section displayed in the section configuration overview or select the section summary entry
at the bottom of the screen to access additional section settings. The Boom Section Settings screen for the
selected section will display.
4. The Section Width for the section is displayed at the top of the screen. Touch the displayed value and use
the on-screen keypad to enter a new section width value if necessary.
5. Touch the Left/Right offset value and use the on-screen keypad to enter the distance of the section
midpoint from the GPS antenna. If the section is offset to the left of the GPS antenna, enter a negative
value for the Left/Right offset value.
Note:
The left/right offset must be measured parallel to the boom or implement width. Select the More
Info button to display an overview of the offset measurements and directions.
6. Touch the Fore/Aft offset value and use the on-screen keypad to enter the distance of the section midpoint
from the GPS antenna. If the section is behind the GPS antenna, enter a negative value for the Fore/Aft
offset value.
7. Touch Next to advance to the next boom or implement section to the right or Prev to go back to the
previous section to the left.
8. Once the width and offset values are entered correctly for each boom or implement section, touch the OK
button to return to the Boom Setup Summary screen.
9. Verify that the section configuration overview represents the actual application equipment or implement
configuration.
10. Press OK to save the section settings and return to the Viper Pro main screen.