Seed Hawk Raven 2012 - Manual (Page 204)

Chapter 11
192 Seed Hawk® Viper Pro™ Installation & Operation Manual
Configuring Blockage Sensor Loops
To properly monitor the seed delivery system, the Viper Pro must be configured for the number of seed
blockage sensors installed in each section of the drill.
1. Review the Section Setup section on page 39 to configure the air seeder and drill and touch the Next button
on the Section Width Setup screen to display the Blockage Loop 1 Sensor Setup screen.
2. Touch the Number Sensors field and use the on-screen keypad to enter the number of sensors in loop 1
for each configured section of the drill.
Note:
Only enter values for the number of configured sections on the drill. Leave the value at zero for
any unused sections.
3. Touch the Next button and repeat the above process to configure sensor loop 2 if applicable.
4. Touch the OK button to complete the section calibration and save the entered settings.