Seed Hawk Raven 2012 - Manual (Page 31)

3
Manual No. 016-3001-003 19
Installation, Start Up & Registration
To start up the Viper Pro:
1. Press the power button on the Viper Pro. The field computer will take approximately 2 minutes to power up.
Note:
Pressing the power button when the following prompt is displayed on-screen will launch the touch
screen calibration wizard without displaying the Program Selection Menu.
This prompt is displayed for approximately five seconds and may be ignored to display the
Program Selection Menu as normal.
2. The Program Selection Menu will display if the Viper Pro was powered off at this screen the last time the
field computer was on.
Note:
To skip the Program Selection Menu next time the Viper Pro is powered up, shutdown the field
computer from the Viper Pro application. Within the Viper Pro application, touch the Menu button
in the lower, right corner of the screen and select Exit, Shutdown Viper.
Pressing and holding the Power button to shutdown the Viper Pro is not recommended. This
procedure should only be used in situations when normal shutdown is not possible.